iHeater

Topic	Replies	Views	Activity
iHeater Chat / iHeater чат ▶ 🇷🇺 Русский ▶ 🇬🇧 English	0	32	April 6, 2026
🔥 iHeater Support & Diagnostics (Question Template)	0	13	March 7, 2026
Chamber temperature not used by iHeater Link	5	11	September 10, 2026
Troubleshooting iHeater Link	0	12	August 30, 2026
iHeater board version 1.2. Anything new?	1	37	August 2, 2026
Factory reset iHeater	2	30	July 21, 2026
iHeater thermistor: tape, sleeve, and what the sensor should actually measure	8	32	March 29, 2026
Choosing an iHeater for the chamber: printer size, heating without the bed, and insulation	7	21	March 29, 2026
Interference and crashes on iHeater: cable, routing, and ferrite	12	22	March 27, 2026
iHeater modification and discussion of airflow through the motor	6	7	March 26, 2026
How to mount the heating element properly: bushings, offset, and clearance from the wall	9	20	March 25, 2026
iHeater enclosure tweaks after importing the STEP into SolidWorks	4	10	March 24, 2026
Power board for the standalone iHeater: what it is and how to connect it	4	37	March 21, 2026
How to ask properly about iHeater on the Anycubic Kobra S1	8	13	March 11, 2026
USB crashes and disconnects when the board is powered from the PSU terminals, but not from the wall outlet	18	27	March 1, 2026
Why iHeater cannot heat the chamber above 65°C	4	13	March 1, 2026
For closed Creality firmware, they recommend using iHeater in standalone mode	9	9	February 28, 2026
Can I order just the iHeater board for chamber heating	4	17	February 28, 2026
Review of iHeater and standalone use	2	12	February 28, 2026
Setting the heating delta in the dryer after assembly	10	7	February 23, 2026
Where to buy iHeater, are there Gerbers, and what to do with spare parts	12	12	February 19, 2026
When will iDryerX / iHeater kits and ready-made units be available	2	7	February 11, 2026
Too high output temperature and case warping	5	11	February 2, 2026
Preorder and estimated price for the iHeater + Unit kit	5	8	January 29, 2026
Where to find documentation and Gerber files for the iHeater and iDryer Unit boards	3	11	January 22, 2026
Checking the optocoupler and triac on the heater line	8	13	January 20, 2026
Where to place the temperature sensor in the printer chamber for the heater	1	8	January 20, 2026
Setting the heater delta and reaching 90°C by air temperature	7	8	January 17, 2026
How to flash iHeater and change temperature thresholds/timeouts	3	4	January 16, 2026
Which crimp terminals in the kit are for the heater wiring and what crimper is needed	1	3	January 5, 2026